electrical hookup plans for the last weekend in April

Spent last weekend running wire. Although I did add more Bondo to the keel. This weekend i plan to finish connecting the fridge, horn, and inverter. If it is warm apply fiberglass to the keel.
I discovered that my chart plotter cannot be on wifi and use the gps antenna at the same time.
I feel i will need to remove the forward hatch to repair the gasket.

Popular posts from this blog

Bagatelle bow eye replacement

Image
I tried to go sailing at Lake Somerville spent most of the morning trying to raise the mast. Once we had the mast up we went to launch the boat and found that the motor wouldn't run so we pulled the boat back out and I noticed in the morning that the bow eye was loose. On the way home there was some traffic on 290 coming in. I had to stop suddenly and since the boat wasn't really connected to the winch it slid forward past the winch and so now I have some gel coat to fix. So I decided to pull out the bow eye that I had bought earlier and put it in the holes that were vacanted by the old bow eye. Looking through the hole I could see that there was no obstructions.The bow eye that I purchased was just a little bit different. The dimension up to down was skinnier than the old bow eye and the holes in the bow post The wood that goes at front of the Bow. So taking a hammer I banged the new Boweye in. It fits snugly but then when I went inside the boat ...
Read more

My Saga of Designing and building a Nimble Artic Gin Pole for Mast raising

Image
Bagatelle Gin Pole Design Saga Bagatelle is a Nimble Artic. Her mast weighs about 150 lbs. I can lift maybe 50 lbs above my head. So I find it difficult to raise her mast on my own. I decided to design a gin pole to help lift the mast. I watched a couple of videos on Youtube Raise or Lower a Mast with a Gin Pole (Yachtorial) Andrew Price https://www.youtube.com/watch?v=tM-FjH_DlqY 1971 O'Day Mariner mast Raise with DIY Gin Pole (Brad Builds Tables) https://www.youtube.com/watch?v=JsReBbNHFsw My first concern was how to attach the gin pole. My first try at attachment was to cut the mast end of the gin pole to fit the mast. Then add hooks to the side to provide a connection for a ratchet strap to hold the pole to the mast. I tried to use this to raise the pole, I found that the gin pole would rotate about the mast so to use it, I needed an extra hand or two to steady both the Gin pole and the mast when going up...
Read more

on charging the car during my retirement trip 2023

Image
Fort stockton texas I plugged in the car through the door into the room. El Paso, Texas at the Quality Inn. I ran the cable through the window which I could open and plug it in the room. Truth or consequences New Mexico I ran the cables through the window which I could open and plug it in the room. Albuquerque new mexico At the Red Roof Inn.. I parked close to an exterior plug plugged in the hallway, everything was good.  Crestview New Mexico at the super 8 I could open the window and run the cable through the window, plug it in the room. At The Quality Inn in Baton Rouge. I found an exterior plug by the pool charged the car there. In Lafayette Louisiana. I asked permission to run the cable through a door and plug the car in the hallway. In New Orleans, I stayed at a hotel. That was a mile from a high Speed charger in a park and I walked or skated back-and-forth. From the car to the hotel every night. In Crestview, Florida. I stayed that the Hilton motel (which is not a...
Read more